Upgrades

• Wind generator installed
• 1 8D batteries for house bank + 2 new group 27 batteries
• 1 new start battery
• Controller for wind & solar power
• Navico autopilot installed
• Replaced engine exhaust hose
• Rigger adjusted all standing rigging
• Stern gate with propane tank holders fabricated
• Install new toilet
• Install new fresh water pump
• Install new deck wash down system
• Replace 12V refrigeration system with Adler Barbour Super cold machine
• Install new hose and rebuild manual bilge pump
• replace electric automatic bilge pump
• install GPS with external antenna & selector switch for computer link
• install SSB radio, automatic tuner, with insulated backstay antenna
• replace stereo and install new CD player
• install new 2 pole main breaker for 110V power system
• install galvanic isolator on ground system for 110V anti-cathodic protection
• replace ground conductor for all 110V outlets on boat
• Service all fire extinguishers on board. Add large extinguisher in quarter berth
• electric windlass installed
• replace anchor rode with 275' new 5/16” HD galvanized Ancor chain
• install manual discharge for holding tank with Y valve for selection
• install 2 new halogen light fixtures in salon area
• replace running rigging
• install Dutchman sail flaking system on mainsail
• install 2 new halogen light fixtures at Nav station, head.
• replace alternator with high output Delco-Remy rebuilt unit
• reinsulate refrigerator with polyisocyanurate on all 6 sides
• replace CNG stove gas system with propane
• replace mainsheet traveler
• replace shower sump pump and float switch
• new bottom paint, rebed 2 through hull fittings, add zincs
• replace cutless bearing
• install Interphase Probe sonar
• install EPIRB
• install MOBI radar reflectors (2)
• upgrade all life-vests, flares, Coast Guard emergency equipment list compliant

• Install 2 new 80W Kyocera solar panels
• Install Link 10 battery monitor
• Install 650W 110V inverter
• Replace all toggless on standing rigging,  rigger retuned rig
• Replace all Norseman fittings on lower end of standing rigging
• Repair roller furler base unit assembly
• Replace spinnaker pole with telescoping aluminum whisker pole
• Replace holding tank
• Add cruising spinnaker to sail inventory
• Replace all fuel delivery lines
• Replace copper waste lines and valves
• Replace manual fresh water pump at galley sink
• Replace VHF and install remote microphone in cockpit
• Install 2^nd electric automatic bilge pump with separate float switch and high water alarm
• Install fluorescent fixture in galley
• Replace faucets at galley sink
• Replace drain hoses under galley sink
• Repaint stern of boat with Awlgrip and add new decal
• Install cockpit outlet, bypass switch for alternator cutoff, battery isolator switches
• Replace transmission
• Rebuild starter motor
• Replace batteries with 6V deep-cycle
• Install 2^nd Racor fuel-water separator with complete valve cross-over connections
• Install manifold overflow box

• Recondition Bimini and Dodger
• 500 hour service on engine – new hoses, new injectors, replace all filters, replace fresh water pump on engine, oil change and filter change, thermostat change, adj valves. Diesel tank pumped and flushed.
• Restitch sacrificial cover on Genoa
• Repair mainsail blowout (twice)
• Refaced thru-hull valves for engine and head.
• Recoat with new bottom paint

• Remove teak decks and install new Awlgrip with nonskid
• Fabricate new stainless support for staysail and reinforce bulkhead to strengthen tab-in
• Replace 110V battery charger
• Replace Balmar voltage regulator
• Rebuild wind generator at factory
• Replace hydraulic unit for autopilot
• Replace Interphase Sonar display
• Replace 4 lower shrouds
• Replace transmission coupling trunnions
• Replace gaskets on 3 Lewmar hatches
• Replace fuel pump on engine with 12V electric

• Rebed sonar transducer
• Replace exhaust elbow on engine
• Recoat anti-fouling
• Replace cutless bearing
• Replace batteries with Trojan T105

• Install alarm system
• Replace shaft and coupling
• Replace start battery

• Engine rebalance
• Replace float switches for both electric bilge pumps
• Replace bilge pump #1
• Replace faucets in head and galley
• Repaint antifouling

• Replace heat exchanger
• Replace salt-water pump on engine
• Replace exhaust elbow on engine
• Acidize heat exchanger
• Replace sea water pump for Adler Barbour frig system
• Install backflow preventer in raw water system.
• Inspect all chain plates

2008

•   Replace all injector lines with Kyocera factory parts
•   Replace VHF radio with ICOM M422
•    Install RAM VHF Microphone in cockpit
•    Install new Stack Pack style mainsail bag
•    Replace mainsail